WattMaster WCC III part 4 - Manual (Page 86)

WCC3.EXE SCREEN DESCRIPTIONS
WCC III Technical Guide 3-82
Mode when using the Analog Mode
The “alt” message will appear here when the Analog Mode
Alternative Setpoint is active. When the status of the binary input
which has been entered in the Binary Output Screen to select the
“Analog Mode - Alternative controlled by” is “ON”, the alternative
setpoint is used, and the “alt” message will appear here.
Run Time
A trend logging feature which allows the WCC III to accumulate
the amount of time a binary output has currently been “ON” or
“OFF.” It will reset to zero and start over the next time it comes
on.
Time Delay “Keep on Time”
When the binary output is on time to go off, this Time Delay will
keep it on an additional number of minutes.
Total Run Time
This is the current accumulated run time.
On Count
This is how many times the binary output has changed from “OFF”
to “ON”.
Last On Time
This is the time and date that the input was last “ON”. ON = Binary
switch contact closed.
Binary Output Summary Screen