Dip switches – Wavetronix Click 111 (16-channel Contact Closure Eurocard) (CLK-111) - User Guide User Manual
Page 11
10
CliCk 111 • User GUIde
Location
No
No
Yes
Device ID
No
No
Yes
Fault Detect Time
No
No
Yes
To use this
configuration feature:
Hardware Configu-
ration Mode
Software Configu-
ration Mode
Software Configu-
ration Mode
Table 2 – Click 111 Configuration Options
The final row on the table refers to configuration modes. The DIP switches can be used to
choose between Hardware and Software modes. If the switches are set to Hardware mode,
the DIP switches will be used to change configuration options. If the switches are set to Soft-
ware mode, the front panel menu and Click Supervisor will be used to change configuration
options. This will be discussed in greater detail in the DIP Switches section next.
Note
Any setting which has been configured via the DIP switches will be read-only in Click
Supervisor and the front panel menu.
DiP Switches
The DIP switches are located on the circuit board behind the faceplate.
Note
When a Click 111 is delivered, all DIP switches will be in the off position.
The side of the faceplate contains information on configuring using the DIP switches, as
shown in Figure 5.