Wavetronix Click 111 (16-channel Contact Closure Eurocard) (CLK-111) - User Guide - Manual (Page 28)

CliCk 111 • User GUIde 27
the device goes into a fault state it will send a call on the master fault output; this parameter
allows you to choose whether that call is high voltage or low voltage.
Level 1 LEDs Fault Output Polarity
Level 2 LEDs
High asserted
Low asserted LED off
LED on
Cancel and exit menu
Table 15 – Front Panel Menu Fault Output Polarity Settings
See the earlier Navigating through the Menu and the Menu Operation Example sections for
how to configure this parameter.
Because this parameter can also be set by the DIP switches, you may need to ensure that the
DIP switches are set to Software configuration mode; if they are set to Hardware, the front
panel menu will be able to display but not change these settings.
Fault Enable
The next parameter on the front panel menu label is fault enable. To select this parameter,
release the push-button when the green and red LEDs come on solid.
Note
This parameter can also be changed using the DIP switches or Click Supervisor.
This parameter lets you choose whether the device will go into a fault state at all. If faults are
disabled, the device will never go into a fault state.
Level 1 LEDs Fault Enable
Level 2 LEDs
Faults enabled (default)
Faults disabled
LED off
LED on
Cancel and exit menu
Table 16 – Front Panel Menu Fault Enable Settings
See the earlier Navigating through the Menu and the Menu Operation Example sections for
how to configure this parameter.