Westermo ID-90 - Manual (Page 106)

106 6607-2204
Table 8
AT!#UD Last Call Status Report Format
Key Value(s) Definition
0 2 digits Diagnostic Command Specification revision number, digit.digit
1Table 9 Call Setup Result code
2 Table 10 Multi-media mode
3 Table 11 DTE-DCE interface mode
4 String V.8 CM octet string, same format as V.250, in quotes
5 String V.8 JM octet string, same format as V.250, in quotes
10 0–2F Received signal power level, in –dBm (0-43)
11 0–1F Transmit signal power level, in –dBm (e.g., 0–17)
12 0–64 Estimated noise level, in –dBm (e.g., 10–90)
17 0–FFF Round Trip delay, in units of ms
18 Table 12 V.34 INFO bit map
20 Table 13 Transmit Carrier Negotiation Result
21Table 1 3 Receive Carrier Negotiation Result
22 0–1F40 Transmit Carrier symbol rate (0–8 000) in symbol/s
23 0–1F40 Receive Carrier symbol rate (0–8 000) in symbol/s
24 0–FA0 Transmit Carrier frequency (0–4 000) in Hz
25 0–FA0 Receive Carrier frequency (0–4 000) in Hz
26 0–FA00 Initial transmit carrier data rate (0–64 000) in bit/s
27 0–FA00 Initial receive carrier data rate (0–64 000) in bit/s
30 0–FF Temporary carrier loss event count
310–FF Carrier Rate re-negotiation event count
32 0–FF Carrier Retrains requested
33 0–FF Carrier Retrain requests granted
34 0–FA00 Final transmit carrier data rate in bit/s
35 0–FA00 Final receive carrier data rate in bit/s
40 Table 14 Protocol Negotiation Result
410–400 Error Control frame size in bytes
42 0–FF Error control link timeouts in transmission
43 0–FF Error control link NAKs received
44 Table 15 Compression Negotiation Result
50 0–2 Transmit flow control: 0 = off; 1 = DC1/DC3; 2 = V.24 ckt 106/133
51 0–2 Receive flow control: 0 = off; 1 = DC1/DC3; 2 = V.24 ckt 106/133
52 0–FFFFFFFF Transmit characters sent from DTE
53 0–FFFFFFFF Received characters sent to DTE
54 0–FFFF Transmit characters lost (data overrun errors from DTE)
55 0–FFFF Received characters lost (data overrun errors to DTE)
56 0–FFFFFFFF Transmit I- Frame count, if error control protocol running
57 0–FFFFFFFF Received I-Frame count, if error control protocol running
58 0–FFFF Transmit I-Frame error count, if error control protocol running
59 0–FFFF Received I- Frame error count, if error control protocol running
60 Table 16 Termination Cause
610–FF Call Waiting event count.