Westermo ID-90 - Manual (Page 40)

40 6607-2204
S-registers
Table 1
Register Function Range Units Saved Default
S0Rings to Auto-Answer 0 –255 rings * 1
S1 Ring Counter 0–255 rings 0
S2 Escape Character ASCII 0–255 ASCII * 43 (02Bh)
S3 Carriage Return Character 0–127 ASCII 13 (0Dh)
S4 Line Feed Character 0–127 ASCII 10 (0Ah)
S5 Backspace Character 0–128 ASCII 8
S7 Wait Time for Carrier, Silence,
or Dial Tone
1–255 s * 30
S9 Enable PNP functionality
for Windows
0–1 ASCII 1
S10Lost Carrier To Hang Up Delay 1–255 0 .1 s * 14
S16 Last occurred CAPI/ISDN
error cause
– –
S36 LAPM Failure Control – – * 7
S40 General Bit-Mapped
Options Status
– – * 104 (68h)
S41 General Bit-Mapped
Options Status
– – * 195 (C3h)
S46 Data Compression Control – – * 138
S48 V.42 Negotiation Control – – 7
S86 Analogue Call Failure Indication 0–26 – 0
S90Last incoming ISDN
calling number (CLIP) – –
S91 PSTN Transmit Attenuation Level 0–15 dBm 10 (Country
dependent)
S92 Fax Transmit Attenuation Level 0–15 dBm 10 (Country
dependent)
S93 Unknown AT command handling 0,1 ASCII * 0
S210 V.34 Symbol Rate 0–255 – 13 (0Dh)
Register Function Range Units Saved Default Note
S0 Rings to Auto-Answer 0–255 rings * 1
S1Ring Counter 0–255 rings 0
S2 Escape Character ASCII 0–255 ASCII * 43 (02Bh)
S3 Carriage Return Character 0–127 ASCII 13 (0Dh)
S4 Line Feed Character 0–127 ASCII 10 (0Ah)
S5 Backspace Character 0–128 ASCII 8
S6 Dial delay 0–255 ASCII *
S7 Wait Time for Carrier, Silence,
or Dial Tone
0–60 s * 50
S9 Enable PNP functionality
for Windows
0–1ASCII 1
S10 Lost Carrier To Hang Up Delay 1–255 0.1 s * 14 1
S16 Last occurred CAPI/ISDN
error cause
– –
S36 LAPM Failure Control – – * 7 1
S40 General Bit-Mapped 1
Options Status – – * 104 (68h)
S41 General Bit-Mapped 1
Options Status – – * 195 (C3h)
S46 Data Compression Control – – * 138 1
S48 V.42 Negotiation Control – – 7 1
S86 Analogue Call Failure Indication 0–26 – 211
S90 Last incoming ISDN
calling number (CLIP)
– –
S91 PSTN Transmit Attenuation Level 0–15 dBm 13 1
S92 Fax Transmit Attenuation Level 0–15 dBm 13 1
S93 Unknown AT command handling 0,1ASCII * 0
S210 V.34 Symbol Rate 0–255 – 13 (0Dh) 1
Note 1. Only present when analogue option is V90 or V34
* Register value may be stored in the user profiles with the &W command.