Westermo ID-90 - Manual (Page 32)

32 6607-2204
#M – Received CLID
Shows the called line identification (CLID) that is received with an incoming call – this is
the number of the called party addressed on the local S-bus (selected msn).
AT#M
! +MS – Modulation Selection
This extended-format compound parameter controls the manner of operation of the modu-
lation capabilities in the modem. It accepts six subparameters:
AT!+MS=[<carrier>[,<automode>[,<min_tx_rate>[,<max_tx_rate>[,<min_rx_rate>[,<ma
x_rx_rate>]]]]]]
Where: Possible <carrier>, <min_tx_rate>, <max_tx_rate>, <min_rx_rate>, and
<max_rx_rate values are listed below.
!+MS Command Supported Rates
Modulation
<carrier> Possible (<min_rx_rate>, <max_rx_rate>, (<min_tx_rate>)
and <max_tx_rate>) Rates (bit/s)
Bell 103 B103 300
Bell 212 B212 1 200 Rx/75 Tx or 75 Rx/1 200 Tx
V.21 V21 300
V.22 V22 1 200
V.22 bis V22B 2 400 or 1 200
V.23 V23C 1 200
V.32 V32 9 600 or 4 800
V.32 bis V32B 14 400, 12 000, 9 600, 7 200 or 4 800
V.34 V34 33 600, 31 200, 28 800, 26 400, 24 000, 21 600, 19 200,
16 800, 14 400, 12 000, 9 600, 7 200, 4 800 or 2 400
V.90 V90 56 000, 54 667, 53 333, 52 000, 50 667, 49 333, 48 000,
46 667, 45 333, 42 667, 41 333, 40 000, 38 667, 37 333,
36 000, 34 667, 33 333, 32 000, 30 667, 29 333, 28 000
K56flex K56 56 000, 54 000, 52 000, 50 000, 48 000, 46 000, 44 000,
42 000, 40 000, 38 000, 36 000, 34 000, 32 000
Defined Values
<carrier>
A string which specifies the preferred modem carrier to use in originating
or answering a connection. <carrier> values are strings of up to eight
characters, consisting only of numeric digits and upper case letters.
<carrier> values for ITU standard modulations take the form:
<letter><1-4digits><other letters as needed>.
<automode> A numeric value which enables or disables automatic modulation
negotiation (e.g., ITU-T V.32 bis Annex A or V.8).
0 = Automode disabled.
1 = Automode enabled. (default)
<min_rx_rate> Numeric values which specify the lowest (<min_rx_rate>) and highest
and rate at which the modem may establish a receive connection. May be
<max_rx_rate> used to condition distinct limits for the receive direction as distinct from
the transmit direction. Values for this subparameter are decimal encoded,
90