Westermo ID-90 - Manual (Page 31)

31 6607-2204
!I – Display version information for analog V.90 option
Displays different information about version number and settings for the analog V.90
modem :
AT!I0 Reports product code, e.g., 56 000
AT!I1 Reports the least significant byte of the stored checksum in decimal
(see firmware release notes). Reports 255 if the prestored checksum
value is FFh.
AT!I2 Reports “OK”.
AT!I3 Reports identification codes in the form VX.X-F_A where:
VX.X = Firmware version (e.g., V3.400)
F =
Firmware model and ROM Size:
V90 or V34 = V90 or V34 in 1M ROM
V90_2M or V34_2M = V90 or V34 in 2M ROM
A = Application
DLP = Desktop parallel
Example: V3.400-V90_2M_DLP
AT!I4 Reports OEM Manufacturer string e.g.: Westermo ID-90 V90
AT!I5 Reports Country Code parameter, e.g., 42.
AT!I6 Reports modem data pump model and internal code revision, e.g.,
RCV56DPF-PLL L8571A Rev 39.00/39.00
AT!I7 Reports OK.
&K – Flowcontrol
Selects the flow control behaviour of the ID-90 while in data communication phase.
AT&K0No local flow control between the DTE and ID-90 is used
AT&K3 Local flow control is set to hardware handshake RTS/CTS (default)
AT&K4 Local flow control is set to software handshake XON/XOFF
!-K – MNP Extended Services
Enables or disables conversion of a V.42 LAPM connection to an MNP 10 connection.
The parameter value, if valid, is written to S40 bits 0 and 1.
AT!-K0 Disables V.42 LAPM to MNP 10 conversion. (default)
AT!-K1 Enables V.42 LAPM to MNP 10 conversion.
AT!-K2 Enables V.42 LAPM to MNP 10 conversion; inhibits MNP Extended
Services initiation during V.42 LAPM answer mode detection phase.
!%L – Report Line Signal Level
Returns a value which indicates the received signal level. The value returned is a direct
indication of the receive level at the MDP, For example, 009 = –9 dBm, 043 = –43 dBm,
and so on. This command is only valid in online command mode.
90
90
90