Westermo ID-90 - Manual (Page 77)

77 6607-2204
maxretries – Max number of retries on sending
alarm messages
With this command you can set the maximum allowed retries on sending an alarm mes-
sage. The highest allowed value for maxretries = 9 (default = 0).
message – Text message setting
With this command you can set the message text that will be sent at an alarm trig.
There is one entry for each alarm input.
messagex mm Set entry number x to message text mm.
messagex - Clear entry number x.
messagex Show entry number x.
message Show all entries.
Maximum number of entries = 4.
Maximum length of message text = 20.
Example: message command (show all entries)
message1: Alarm on input 1
message2: Motor 4 over temp
message3:
message4:
msn – Multiple Subscriber Number
Own MSN (Multiple Subscriber Number)
*: no specific MSN, all incoming calls accepted
The msn is automatically stored to non volatile ram.
mtype – Transfer method for alarm message
With this command you can set up the transfer method for an alarm message.
Selectable transfer methods are SMS, and Hotline text
There is one mtype entry for each alarm input.
mtypex n Set entry number x to method number n.
mtypex - Clear entry number x
mtypex ? Show all selectable transfer methods
mtypex Show entry number x
mtype Show all entries
Maximum number of entries = 4.
0: SMS text (UCP) according to UCP- (Universal Computer Protocol)
(default)
1: Hotline text (expects a <CR> acknowledged from receiver to
avoid retries)
2: SMS text (TAP) (Telocator Alpanumeric Protocol)