3 shutdown, 3 network management port configuration, 1 network management port configuration task list – Accton Technology ES4626 User Manual
Page 142
142
the VLAN interface, otherwise, the IP address configured will be the secondary IP
address for the VLAN interface. A VLAN interface can have one primary IP address but
multiple secondary IP addresses. Both primary IP address and secondary IP addresses
can be used for SNMP/Web/Telnet management. In addition, ES4624/26-SFP allows IP
addresses to be obtained through BootP/DHCP.
Example:
Setting the IP address of VLAN1 interface to 192.168.1.10/24.
Switch(Config-If-Vlan1)#ip address 192.168.1.10 255.255.255.0
3.2.2.2.3 shutdown
Command: shutdown
no shutdown
Function:
Shuts down the specified VLAN Interface; the “no shutdown” command
opens the VLAN interface.
Command mode:
Interface Mode
Default:
VLAN Interface is enabled by default.
Usage Guide:
When VLAN interface is shutdown, no data frames will be sent by the
VLAN interface. If the VLAN interface needs to obtain IP address via BootP/DHCP
protocol, it must be enabled.
Example:
Enabling VLAN1 interface of the switch.
Switch(Config-If-Vlan1)#no shutdown
3.2.3 Network Management Port Configuration
3.2.3.1 Network Management Port Configuration Task List
1. Enter the network management port configuration mode
2. Configure the properties for the network management ports
（
1） Enable/Disable ports
（
2） Configure port speed
（
3） Configure port duplex mode
（
4） Enable/Disable port loopback function
（
5） Configuring port IP Address
1. Enter the network management port configuration mode
Command Explanation
Global Mode
interface ethernet <num>
Enters the network
management port
configuration mode