Accton Technology ES4626 - Manual (Page 489)

489
IPv6 ospf dead-interval <time>
[instance-id <id>]
no IPv6 ospf dead-interval
[instance-id <id>]
Sets the interval before regarding a neighbor
layer3 switch invalid; the “no IPv6 ospf
dead-interval [instance-id <id>] ” command
restores the default setting.
IPv6 ospf transit-delay
<time>
[instance-id <id>]
no IPv6 ospf transit-delay
[instance-id <id>]
Sets the delay time before sending link-state
broadcast; the “no IPv6 ospf transit-delay
[instance-id <id>] ” command restores the
default setting.
IPv6 ospf retransmit <time>
[instance-id <id>]
no IPv6 ospf retransmit
[instance-id <id>]
.Sets the interval for retransmission of
link-state advertisement among neighbor
layer3 switches; the “no IPv6 ospf
retransmit [instance-id <id>] ” command
restores the default setting.
（2）Configure OSPFv3 route introduction parameters
Configure OSPFv3 route introduction parameters
Commands Explanation
OSPF Protocol Configuration Mode
[no]redistribute {kernel |connected|
static| rip| isis| bgp} [metric <value>]
[metric-type {1|2}][route-map<word>]
Introduces other protocol discovery
routing and static routing regarded as
external routing message. The
[no]redistribute {kernel |connected|
static| rip| isis| bgp} [metric <value>]
[metric-type {1|2}][route-map<word>]
command cancels imported external
routing message.
（3） Configure Other Parameters of OSPFv3 Protocol
1） Configure OSPFv3 STUB Area & Default Routing Cost
2） Configure OSPFv3 Virtual Link
Commands Explanation
OSPFv3 Protocol Configuration Mode
timers spf <spf-delay> <spf-holdtime>
no timers spf
Configure OSPFv3 SPF timer. The no
timers spf command recovers default
value.