1 commands for ipv6 configuration, 1 ipv6 enable, 2 ipv6 address – Accton Technology ES4626 User Manual
Page 287
287
[no] tunnel mode ipv6ip | 6ot4 |
isatap
Configure tunnel mode. The NO command
clears tunnel mode.
（7）
Configure Tunnel Routing
Command Explanation
Global mode
[no] ipv6 route
<ipv6-address/prefix-length>
{<interface-type
interface-number> | tunnel
<tnl-id>}
Configure tunnel routing. The NO command
clears tunnel routing.
9.2.2.3.1 Commands for IPv6 configuration
9.2.2.3.1.1 ipv6 enable
Command：[no] ipv6 enable
Function：
This command enables functions such as Unicast IPv6 Data Packet Transmit,
Neighbor Discover, Router Bulletin and Routing Protocol, etc.
Parameter：
None
Command Mode：
Global Mode
Default：
Disable IPv6 Enable switch
Usage Guide：
To enable ipv6 enable command will allow configuring IPv6 command and
process IPv6 data transmission.
Example：
Turn on IPv6 Enable switch under Global Mode.
Switch(Config)#ipv6 enable
9.2.2.3.1.2 ipv6 address
Command：ipv6 address
<ipv6-address/prefix-length> [eui-64]
no ipv6 address
<ipv6-address/prefix-length> [eui-64]
Function：
Configure agregatable global unicast address, local site address and local link
address for the interface
Parameter ：
Parameter <ipv6-address> is the prefix of IPv6 address, parameter
<prefix-length>
is the distance of the prefix of IPv6 address, which is between 3-128,
eui-64
means IPv6 address is generated automatically based on eui64 interface identifier
of the interface
Command Mode：
Interface Configuration Mode
Default：
None