Accton Technology ES4626 - Manual (Page 555)

555
<0-65535> : TCP port number
Default:
Default port number is 179
Command Mode: BGP mode and address-family mode
Usage Guide: This is a configuration when the partner may connect through ports not
specified by BGP
Example: Switch(config-router)#neighbor 10.1.1.64 port 1023
13.8.3.64 neighbor prefix-list
Command:neighbor {<ip-address>|<TAG>} prefix-list <LISTNAME|number>
{<in|out>}
no neighbor {<ip-address>|<TAG>} prefix-list <LISTNAME|number>
{<in>|<out>}
Function: Configure the prefix restrictions applied in sending or receiving routes from
specified neighbors.The “no neighbor {<ip-address>|<TAG>} prefix-list
<LISTNAME|number> {<in>|<out>} ” command cancels this configuration
Parameter: <ip-address>
: Neighbor IP address
<TAG> : Name of the peer group
<LISTNAME|number> : Name or sequence number of the prefix-list
<in|out> : Direction on which the restrictions applied
Default: No prefix restrictions applied
Command Mode: BGP mode and address-family mode
Usage Guide: Specify the prefix and its scope by configuring ip prefix-list and determines
whether this scope is permitted or denied. Only the route with permitted prefix will be sent
or received
Example:
Switch(config)#ip prefix-list prw permit 100.1.0.0/22 ge 23 le 25
Switch(config)#router bgp 200
Switch(config-router)#redistribute static
Switch(config-router)neighbor 10.1.1.66 prefix-list prw out
13.8.3.65 neighbor remote-as
Command:neighbor {<ip-address>|<TAG>} remote-as <as-id>
no neighbor {<ip-address>|<TAG>} [remote-as <as-id>]
Function: Configure the BGP neighbor. The “no neighbor {<ip-address>|<TAG>}
[remote-as <as-id>] ” command is used for deleting BGP neighbors.
Parameter: <ip-address> : Neighbor IP address
<TAG>
: Name of peer group
<as-id>: : Neighbor AS number ranging between 1-65535