Accton Technology ES4626 - Manual (Page 531)

531
Switch(config-router)#bgp bestpath med confed missing-as-worst
Relevant Commands: bgp bestpath compare-confed-aspath, bgp bestpath
compare-confed-aspath, bgp bestpath compare-routerid, no bgp bestpath
compare-confed-aspath, no bgp bestpath compare-confed-aspath, no bgp bestpath
compare-routerid
13.8.3.11 bgp client-to-client reflection
Command: bgp client-to-client reflection
no bgp client-to-client reflection
Function: Configures whether the route reflection is performed. The “no bgp
client-to-client reflection ” cancels this configuration
Parameter: None
Default: Reflection defaulted when client is configured.
Command Mode:BGP route mode
Usage Guide: After configured reflection client with neighbor {<ip-address>|<TAG>}
route-reflector-client, the router performs routing reflection in default condition. The NO
form of this command cancels the route reflection among CLIENT, (reflection among
Clients and non-CLIENT is not disturbed.)
Example:
Switch(config-router)#no bgp client-to-client reflection
Relevant Commands: neighbor route-reflector-client, no neighbor
route-reflector-client
13.8.3.12 bgp cluster-id
Command: bgp cluster-id {<ip-address>|<01-4294967295>}
no bgp cluster-id {<[<ip-address>]|<0-4294967295>}
Function: Configure the route reflection ID during the route reflection. The “no bgp
cluster-id {<[<ip-address>]|<0-4294967295>} ” command cancels this configuration
Parameter: <ip-address>|<1-4294967295> : >: cluster-id which is shown in dotted
decimal notation or a 32 digit number.
Default: Not configured
Command Mode: BGP route mode
Usage Guide: consists of routing reflectors and its clients in an area. However in order to
increase the redundancy level, sometime more than one routing reflectors may be
deployed in one area. Router-id is for identifying the router exclusively in an area, and
cluster-id is required for two or more reflector identification.
Example:
Switch(config-router)#bgp cluster-id 1.1.1.1