Accton Technology ES4626 - Manual (Page 377)

377
match clause should at first be defined.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#set metric +60
13.2.3.21 set metric-type
Command: set metric-type <type-1 | type-2>
no set metric-type [<type-1 | type-2>]
Function: Configure the metric type of the OSPF routing message. The “no set
metric-type [<type-1 | type-2>] ” command deletes this configuration.
Parameter: type-1 means matches the OSPS type 1 external route, type-2 means
matches the OSPS type 2 external route.
Command Mode: route-map mode
Usage Guide: To use this command, one match clause should at first be defined.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#set metric-type type-1
13.2.3.22 set origin
Command: set origin <egp | igp | incomplete >
no set origin [<egp | igp | incomplete >]
Function: Configure the origin code of the BGP routing message. The “no set origin
[<egp | igp | incomplete >] ” command deletes this configuration.
Parameter: egp means the route is learnt from the external gateway protocols, igp
means the route is learnt from the internal gateway protocols, incomplete means the
route origin is uncertain.
Command Mode: route-map mode
Usage Guide:
To use this command, one match clause should at first be defined.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#set origin egp
13.2.3.23 set originator-id
Command: set originator-id <ip_addr>
no set originator-id [<ip_addr>]