Accton Technology ES4626 - Manual (Page 551)

551
13.8.3.55 neighbor filter-list
Command: neighbor {<ip-address>|<TAG>} filter-list <.LINE> {<in>|<out>}
no neighbor {<ip-address>|<TAG>} filter-list <.LINE> {<in>|<out>}
Function: Access-list control for AS-PATH. The “no neighbor {<ip-address>|<TAG>}
filter-list <.LINE> {<in>|<out>} ” cancels the AS-PATH access-list control.
Parameter: <ip-address>
: Neighbor IP address
<TAG> : Name of peer group
<LINE>: AS-PATH access-list name configured through ip as-path access-list
<.LINE> <permit|deny> <LINE>.
Default: Not configured
Command Mode: BGP route mode and address list mode
Usage Guide: After first configured the IP AS-PATH access-list, apply this option to
specified neighbor will be able to send/receive routes with specified AS numbers in the
AS list. Accepting or denying depends on the configuration of the access-list, while
sending and receiving are configured by this command.
Example:
Configure the AS-PATH access control list, “ASPF” is the name of the access-list. The
route with AS number of 100 will not be able to update to the partner due to the filter table
control.
Switch(config)#ip as-path access-list ASPF deny 100
Switch(config)#router bgp 100
Switch(config-router)# redistribute static
Switch(config-router)neighbor 10.1.1.66 filter-list aspf out
Relevant Commands: ip as-path access-list
13.8.3.56 neighbor interface
Command: neighbor <ip-address> interface <IFNAM>
no neighbor <ip-address> interface <IFNAM>
Function: Specify the interface to the neighbor. The “no neighbor <ip-address>
interface <IFNAM> “ of the command cancels this configuration
Parameter: <ip-address> : Neighbor IP address
<IFNAME>: Interface name, e.g. “Vlan 2”
Default: Not configured
Command Mode: BGP route mode and address-family mode
Usage Guide:
Specifies the exit interface to the neighbor with this command. Interface
destination accessibility should be ensured
Example:
Switch(config-router)# neighbor 10.1.1.64 interface Vlan2