Verifying the configuration – H3C Technologies H3C S12500-X Series Switches User Manual
Page 285
274
[PE2-xcg-vpn1-svc] ac interface ten-gigabitethernet1/0/1 service-instance 1000
# Create a static PW for the cross-connect to bind the AC to the PW.
[PE2-xcg-vpn1-svc] peer 192.4.4.4 pw-id 1000 in-label 200 out-label 100
[PE2-xcg-vpn1-svc-192.4.4.4-1000] quit
[PE2-xcg-vpn1-svc] quit
[PE2-xcg-vpn1] quit
5.
Configure CE 2:
<CE2> system-view
[CE2] vlan 10
[CE2-vlan10] quit
[CE2] interface vlan-interface 10
[CE2-Vlan-interface10] ip address 100.1.1.2 24
[CE2-Vlan-interface10] quit
[CE2] interface ten-gigabitethernet 1/0/1
[CE2-Ten-GigabitEthernet1/0/1] port link-type trunk
[CE2-Ten-GigabitEthernet1/0/1] port trunk permit vlan 10
[CE2-Ten-GigabitEthernet1/0/1] quit
Verifying the configuration
# Display L2VPN PW information on P. The output shows that two PWs have been created to form a
multi-segment PW.
[P] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 2, 2 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpn1
Peer PW ID In/Out Label Proto Flag Link ID State
192.2.2.2 1000 65669/65655 LDP M 0 Up
192.3.3.3 1000 100/200 Static M 1 Up
# Display L2VPN PW information on PE 1. The output shows that a PW has been created.
[PE1] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpn1
Peer PW ID In/Out Label Proto Flag Link ID State
192.4.4.4 1000 65655/65669 LDP M 1 Up
# Display L2VPN PW information on PE 2. The output shows that a PW has been created.
[PE2] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpn1
Peer PW ID In/Out Label Proto Flag Link ID State
192.4.4.4 1000 200/100 Static M 1 Up
# CE 1 and CE 2 can ping each other.