HEIDENHAIN iTNC 530 (340 49x-04) ISO programming - Manual (Page 153)

HEIDENHAIN iTNC 530 153
4.6 3-D Line Gr
aphics (FCL2-F
u
nction)
Highlighting NC blocks in the graphics
 Shift the soft-key row.
 To highlight the NC block selected in the left window
in the 3-D line graphics in the right window, set the
MARK THIS ELEMENT OFF / ON soft key to ON.
 To not highlight the NC block selected in the left
window in the 3-D line graphics in the right window,
set the MARK THIS ELEMENT OFF / ON soft key to
OFF.
Block number display ON/OFF
 Shift the soft-key row.
 To show block numbers: Set the SHOW OMIT BLOCK
NR. soft key to SHOW.
 To omit block numbers: Set the SHOW OMIT BLOCK
NR. soft key to OMIT.
Erasing the graphic
 Shift the soft-key row.
 Erase graphic: Press CLEAR GRAPHIC soft key.