HEIDENHAIN iTNC 530 (340 49x-04) ISO programming - Manual (Page 18)

18
Changed functions with 340 49x-04
„ DCM: Retraction after collision simplified
„ The input range for polar angles was increased (see “Helical
interpolation” on page 245)
„ The value range for Q-parameter assignment was increased (see
“Programming notes,” page 527)
„ The pocket-, stud- and slot-milling cycles 210 to 214 were removed
from the standard soft-key row (CYCL DEF > POCKETS/STUDS/
SLOTS). For reasons of compatibility, the cycles will still be
available, and can be selected via the GOTO key.
„ The soft-key rows in the Test Run operating mode were modified to
those of the smarT.NC operating mode
„ Windows XP is now used on the dual-processor version (see
“Introduction” on page 682)
„ Loading of values from the pocket calculator was changed (see “To
transfer the calculated value into the program,” on page 161)