HEIDENHAIN iTNC 530 (340 49x-04) ISO programming - Manual (Page 34)

34
9.1 Overview of Special Functions ..... 482
Main menu for SPEC FCT special functions ..... 482
Program defaults menu ..... 482
Functions for contour and point machining menu ..... 483
Define different DIN/ISO functions menu ..... 483
Programming aids menu (only conversational) ..... 484
9.2 The PLANE Function: Tilting the Working Plane (Software Option 1) ..... 485
Introduction ..... 485
Define the PLANE function ..... 487
Position display ..... 487
Reset the PLANE function ..... 488
9.3 Defining the Machining Plane with Space Angles: PLANE SPATIAL ..... 489
Function ..... 489
Input parameters ..... 490
9.4 Defining the Machining Plane with Projection Angles: PROJECTED PLANE ..... 491
Application ..... 491
Input parameters ..... 492
9.5 Defining the Machining Plane with Euler Angles: PLANE EULER ..... 493
Application ..... 493
Input parameters ..... 494
9.6 Defining the Machining Plane with Two Vectors: VECTOR PLANE ..... 495
Application ..... 495
Input parameters ..... 496
9.7 Defining the Machining Plane via Three Points: POINTS PLANE ..... 497
Application ..... 497
Input parameters ..... 498
9.8 Defining the Machining Plane with a Single, Incremental Space Angle: PLANE RELATIVE ..... 499
Application ..... 499
Input parameters ..... 499
9.9 Tilting the working plane through axis angle: PLANE AXIAL (FCL 3 function) ..... 500
Application ..... 500
Input parameters ..... 501
9.10 Specifying the positioning behavior of the PLANE function ..... 502
Overview ..... 502
Automatic positioning: MOVE/TURN/STAY (entry is mandatory) ..... 502
Selection of alternate tilting possibilities: SEQ +/– (entry optional) ..... 505
Selecting the type of transformation (entry optional) ..... 506
9.11 Inclined-Tool Machining in the Tilted Plane ..... 507
Function ..... 507
Inclined-tool machining via incremental traverse of a rotary axis ..... 507
9 Programming: Special Functions ..... 481