HEIDENHAIN iTNC 530 (340 49x-04) ISO programming - Manual (Page 78)

78 2 Manual Operation and Setup
2.2 Mo
ving the Mac
h
ine Ax
es
Features in the Program Run modes of operation
You can use the following functions in the Program Run modes of
operation:
„ NC start (handwheel NC-start key)
„ NC stop (handwheel NC-stop key)
„ After the NC-stop key has been pressed: Internal stop (handwheel
soft keys MOP and then STOP)
„ After the NC-stop key has been pressed: Manual axis traverse
(handwheel soft keys MOP and then MAN)
„ Returning to the contour after the axes were moved manually during
a program interruption (handwheel soft keys MOP and then REPO).
Operation is by handwheel soft keys, which function similarly to the
control-screen soft keys (see “Returning to the contour” on page
594)
„ On/off switch for the Tilted Working Plane function (handwheel soft
keys MOP and then 3D)