HEIDENHAIN iTNC 530 (340 49x-04) ISO programming - Manual (Page 561)

HEIDENHAIN iTNC 530 561
1
1
.1
0 Pr
eassigned Q P
a
ra
met
e
rs
Coordinates after probing during program run
The parameters Q115 to Q119 contain the coordinates of the spindle
position at the moment of contact during programmed measurement
with the 3-D touch probe. The coordinates refer to the datum point
that is active in the Manual operating mode.
The length of the stylus and the radius of the ball tip are not
compensated in these coordinates.
Deviation between actual value and nominal
value during automatic tool measurement with
the TT 130
Tilting the working plane with mathematical
angles: rotary axis coordinates calculated by the
TNC
Coordinate axis Parameter value
X axis Q115
Y axis Q116
Z axis Q117
4th Axis
depending on MP100 Q118
5th axis
depending on MP100 Q119
Deviation of actual from nominal value Parameter value
Tool length Q115
Tool radius Q116
Coordinates Parameter value
A axis Q120
B axis Q121
C axis Q122