SMA SC 500CP XT Installation - Manual (Page 17)

Procedure:
1. Insert all cables through the openings into the base. Make sure that the data cables are routed separately from
the power cables.
2. Seal the opening, e.g. with expanding foam. This will prevent living creatures from getting into the inverter.
3. Fill up the excavation pit and level off to ground level.
4.3 Transporting the Inverter
4.3.1 Transporting the Inverter Using a Pallet Truck
1. If the inverter is to be transported on a wooden pallet, push the
pallet truck under the inverter from the front or the back.
2. If the inverter is to be transported without wooden pallet,
disassemble the kick plates (see Section 7.2.1, page 40).
Move the pallet truck under the inverter from the side only.
Make sure the the side panels of the inverter are not damaged
by the forks.
3. Slightly raise the inverter.
4. Transport the inverter to the mounting location and set it down on a suitable surface.
4 Transport and Mounting SMA Solar Technology AG
Operating Manual 17 SCCPXT-IA-E4-en-44