SMA SC 500CP-US - Manual (Page 50)

7 Transporting the Inverter SMA America, LLC
50 SCCP-US-IA-US_en-41 Installation Manual
8. Slowly lift the inverter.
9. Transport the inverter as close to the ground as possible.
10. Transport the inverter to the mounting location and set down on a suitable surface.
11. Remove all lifting accessories.
7.7.3 Mounting the Roof of the Inverter
After transporting the inverter using the crane, you must mount the roof.
When the inverter is installed in an electrical equipment room, it is not necessary to mount the roof.
Procedure:
1. Place the roof on the inverter.
2. Fasten the roof grounding strap to the inverter.
Torque: 10.5 ft-lbs. (14 Nm).
7. :$51,1*
Danger of crushing if the inverter falls down
If the maximum allowed tilt angle of 60° is exceeded, the specified load-bearing capacity of the lifting accessories
is no longer ensured. The lifting accessories used can tear. This may cause the inverter to fall down.
• Make sure that the maximum allowed tilt angle is not exceeded.
• Observe the manufacturer's specifications for the lifting accessories.
• Keep a sufficiently safe distance from the inverter.
• Wear personal protective equipment for all work on the inverter.
&$87,21
Danger of crushing due to heavy and unwieldy roof
The roof of the inverter weighs 66
1
⁄
4
lbs. (30 kg) and is bulky. Attempting to move the roof alone can result in injuries
from crushing.
• Wear personal protective equipment for all work on the inverter.
• Only move the roof with two people.