Yaskawa SI-ET3 - Manual (Page 7)

3 Receiving
YASKAWA ELECTRIC SIEP C730600 62B 1000-Series Option SI-ET3 Technical Manual 7
3 Receiving
Please perform the following tasks upon receipt of the option:
• Inspect the option for damage. Contact the shipper immediately if the option appears damaged upon receipt.
• Verify receipt of the correct model by checking the model number printed on the name plate of the option package.
• Contact your supplier if you have received the wrong model or the option does not function properly.
‹ Option Package Components
Table 2 Option Package Contents
‹ Tools Required for Installation
• A Phillips screwdriver (M3 metric/#1, #2 U.S. standard size
<1>
) is required to install the option and remove drive front
covers.
• Diagonal cutting pliers. (required for some drive models)
• A small file or medium grit sandpaper. (required for certain drive models)
Note: Tools required to prepare option networking cables for wiring are not listed in this manual.
Description: Option
Ground
Wire
Screws (M3) LED Label Installation Manual
_
Quantity: 1 1 3 1 1
<1> Screw sizes vary by drive capacity. Select a screwdriver appropriate for the drive capacity.
R/E LK1
CON LK2
MANUAL