Yaskawa YASNAC PC NC PLC Programming Manual - Manual (Page 114)

6 - 78
YASNAC PCNC PLC Programming Manual Chapter 6: PLC Instructions
(b) Example
(c) Control conditions
• Designation of the size of the data table (number of bytes) (IPSH X)
Designate the size of the data table by the number of bytes.
• Designation of the start address of the data table (APSH#XXXX)
Designate the start address of the data table
The data table can be created at any place.
• Designation of the input data address (APSH#XXXX)
Designate the address where the data to be searched is stored.
• Designation of the output data address (APSH#XXXX)
When the specified data are found (R1 = 0), the number in the table where the
found data are stored is output. Designate the address where that number is stored.