Yaskawa YASNAC PC NC PLC Programming Manual - Manual (Page 116)

6 - 80
YASNAC PCNC PLC Programming Manual Chapter 6: PLC Instructions
(b) Example
(c) Control conditions
• Designation of the size of the data table (number of bytes) (IPSH X)
Designate the size of the data table by the number of bytes.
• Designation of the start address of the data table (APSH#XXXX)
Designate the start address of the data table
The data table can be created at any place.
• Designation of the address storing the I/O data (APSH#XXXX)
Designate the address where the data to be searched is stored.
• Designation of the address storing the number in the table (APSH#XXXX)
The data to be read or rewritten is designated by the number in the table.
Designate the address where this number is stored.