Yaskawa YASNAC PC NC PLC Programming Manual - Manual (Page 169)

8 - 21
YASNAC PCNC PLC Programming Manual Chapter 8: Online Editing
8.4.4 Inputting Vertical and Horizontal Lines
By using the function soft-key s [ — ] or [ __ ], a vertical line of a horizontal line can be input at the
cursor position.
When inputting a vertical line, the content of line display varies depending on the cursor position
and the instructions existing around the cursor. How the vertical line is input is shown below.
After the correct input of the vertical or horizontal line, the input instruction is reflected to the
ladder chart. The cursor position is not changed before or after the input of the varietal/horizontal
line.
The example of the screen below shows the vertical line input operation.
Since a horizontal line does not exist in the upper right of the cursor, the vertical line is drawn
upward.
Fig. 8.12 Drawing a Vertical Line