Yaskawa YASNAC PC NC PLC Programming Manual - Manual (Page 147)

7 - 20
YASNAC PCNC PLC Programming Manual Chapter 4: Sequence Control Method
7.5 List of Messages
7.5.1 Error Messages
1-line character over
Illegal character is used.
Over the nest of source-file
Illegal character is used instead of pseudo-instruction.
A pseudo-instruction is used duplicatedly.
‘ ENDP’ cannot be found.
Characters of a word is too long.
Invalid operator.
Object-file memory size over.
Operand of an instruction is not enough.
Operand-address is not correct.
Operand-byte-data is not correct.
Operand-word-data is not correct.
Label define error.
SUBP number is not correct.
Label define error.
Total number of defined-label exceeds 256.
Stop-count-setting-range is not correct.
Table-number define error.
Table-number-setting-range is not correct.
Character data define error.
Character data range define error.
Character data lines over.
Variable number error.
Out instruction address range over.
Timer-register range error.
Number of MCR & END is unmatch.
Byte data define error.
Word data define error.
Data range define error.
Number of Operands are too large, or Include valid characters.
Nest of MCR over.