Yaskawa YASNAC PC NC PLC Programming Manual - Manual (Page 164)

8 - 16
YASNAC PCNC PLC Programming Manual Chapter 8: Online Editing
(2) Function Soft-key s
: Replaces the block where the cursor is positioned with the NO contact.
If this key is pressed when the cursor is positioned on the block which
includes a register instruction, the remaining block is deleted as indicated
below.
: Replaces the block where the cursor is positioned with the NC contact.
If this key is pressed when the cursor is positioned on the block which
includes a register instruction, the remaining block is deleted as indicated
below.
: Replaces the block where the cursor is positioned with the OUT coil.
If this key is pressed when the cursor is positioned on the block which
includes a register instruction, the remaining block is deleted as indicated
below.
Note: An OUT coil can be input only at the 13th contact. If it is input at
any other position, and error occurs and “INPUT ERROR” message us dis-
played.
: Replaces the block where the cursor is positioned with a horizontal line
“—”.
If this key is pressed when the cursor is positioned on the block which
includes a register instruction, the remaining block is deleted as indicated
below.
If this key is pressed when the cursor is positioned on the block of the hor-
izontal line “—”, the horizontal line is deleted.