Yaskawa YASNAC PC NC PLC Programming Manual User Manual
Page 157

8 - 9
YASNAC PCNC PLC Programming Manual Chapter 8: Online Editing
8.3.4
GO/STP (Run/Stop) Function
By using the [
GO/STP
] function
soft-key
, the sequence program execution (run, stop) can be con-
trolled. At the start of sequence program execution, correctness of the sequence program is
checked. During this check, the message “LADDER CHECKING” is displayed. If an error is
found during this check, the sequence program cannot be executed even if the [
GO/STP
] function
soft-key
is depressed.The content of the error found during the check is displayed by the corre-
sponding warning message.
Note that the [
GO/STP
] function
soft-key
is not valid while the NC is running. After the start of
the sequence program, message <EXEC> is displayed on the screen.
Fig. 8.3
Before the execution of the sequence program, its correctness is checked.