Yaskawa YASNAC PC NC PLC Programming Manual - Manual (Page 199)

10 - 9
YASNAC PCNC PLC Programming Manual Chapter 10: YASNAC Paradym-31
10.9 Restrictions in Paradym-31 Debug Mode
The following restrictions exist when the CNC device is in the Paradym-31 debug mode.
(1) The ladder display and ladder on-line edit function of the CNC device are disabled. When
the ladder display key is pressed, the warning message “P31 is being selected” is shown
on the CNC display.
(2) The input/output of the NC data (parameter, working program, offset data) based on the
Paradym-31 is disabled. (In the case of YASNAC J100M, J100L, parameter input/output
based on PC card is possible).
10.10 Additional Parameters
pm5014 d5: Paradym-31 debug mode selection parameter
0: Invalidate the communication between the Paradym-31 and CNC device
1: Validate the communication between the Paradym-31 and CNC device
• When this parameter is changed, the NC alarm “ALM0050: PARAM
REQUIRING POWER OFF” is displayed. Therefore, after the NC power is
turned off, turn the NC power on again.
• This parameter is enabled only when the rotary switch used for system set-up
is “4”.
Important