Yaskawa MP900 Series Machine Controller Programming Panel for Simple Operation - Manual (Page 26)

Setup Wizard
2.2.4 Module Settings
2-14
2
2. SVB Configuration
Data on the SVB-CH1 or SVB-CH2 configuration will be displayed.
The following illustration shows the SBV Configuration Window in detail.
a) Number of Servos
Select the number of Servos from the drop-down list.
A value between 1 and 14 will be displayed in the drop-down list.
b) Number of I/O Units
Select the number of I/O Units from the drop-down list.
A value between 1 and 14 will be displayed in the drop-down list.
1 The maximum total number of Servos and I/O Units is 14.
2 The background of a displayed value in the drop-down list will be gray if the total exceeds 14 with the
value selected. Furthermore, the background of the box will also be gray.
3 The number of Servos and I/O Units selected will be reflected to the number of Servos and I/O Units
(a), the number of Servos (b), and the number of I/O Units (c) in 1 Servo and I/O Settings.
c) Servo and I/O Unit Allocation
Select the Servo or I/O Unit for each station from the drop-down list.
The number of Servos and I/O Units that has been set in the above can be allocated.
An excessive number of Units cannot be set.
It will not be possible to go to the next window unless the following two items are set correctly.
1 Check that the number of Servos or I/O Units that has been set is the same as that set for Servo and I/O
allocations.
2 The number of Servos is 1 or larger.
3. Back Button
The window will change to the Setup Wizard 3: Network Window when this button is
clicked.
4. Next Button
The window will change to the Setup Wizard 5: Confirm the Configuration Window
when this button is clicked.
a)
b)
c)
INFO
INFO