3 creating auto_mplcd – Yaskawa MPLoad Maker User Manual
Page 16
Advertising
4 Creating Auto_MPLCD
4.3 Creating Auto_MPLCD
16
4.3 Creating Auto_MPLCD
Use a CD-RW device or driver to write the created Auto_MPL (shown below) onto a CD-ROM. The Auto_MPL writ-
ten onto the CD-ROM is called Auto_MPLCD.
Write four sets of data in the work folder onto a CD-ROM.
MPLoad Maker can not be used to reuse rewritable disks.
When writing the Auto_MPL onto a CD-ROM, a message for directory level may appear. If the writing operation is
interrupted, change the settings. For example, change the write directory level to a level higher than 10.
If the created Auto_MPLCD is left in the CD-ROM drive, the Auto_MPL will automatically start running. Be sure to
remove the Auto_MPLCD from the CD-ROM drive when writing is completed.
Advertising