Olympus OM-D E-M1 Mark II - Manual (Page 101)

101 EN
Menu functions (V
ideo menu)
4
Option Description
g
n Display Settings [n Control Settings]: Sets whether to display Live Control
(P. 126) and Live SCP (P. 50) in movie mode. For setting not to
display, select the item and press the
Q button to clear the
check mark.
[
n Info Settings]: Sets the information to be displayed
on the movie recording screen. For setting not to display,
select the item and press the
Q button to clear the check
mark.
[ Time Code Settings]: Set the time codes to record for
movie mode.
Set [Time Code Mode] to [Drop Frame] to record time
codes corrected for errors with respect to recording time,
and to [Non-DF] (no drop frame) to record uncorrected time
codes.
Set [Count Up] to [Rec Run] to run time codes during
recording only, and to [Free Run] to run time codes even
while recording is stopped, including when the camera is
turned off.
In [Starting Time], set a starting time for the time code. Set
[Current Time] to set the time code for the current frame to
00. To set to 00:00:00:00, select [Reset]. You can also set
time codes using [Manual Input]. Time codes cannot be
recorded in Motion JPEG (H).
[
8 Display Pattern]: Sets the battery level display (“%” or
“minutes”) in movie mode and during movie recording.
—
Movie K Audio will not be recorded in a movie when set to [Off]. 103
n HDMI Output
Sets the output setting for recording movies with this
camera connected with an external device via HDMI.
[Output Mode]: Sets the video output mode. When set to
[Monitor Mode], image and camera information are output.
The camera information is not displayed on the camera
screen.
When set to [Record Mode], only image is output. The
camera information is displayed on the camera screen.
[REC Bit]: If set to [On], the REC trigger is sent from the
camera to the connected external device.
[Time Code]: If set to [On], the time code is sent from the
camera to the connected external device.
• The recording by the external device that uses the time
code as the REC trigger may be stopped in the following
cases.
- When recording an ART movie, etc., under heavy
processing load
- When switching the display between the monitor and
viewfi nder
—