Epson AcuLaser CX37DNF - Manual (Page 40)

5. In Administrator mode of Web-Based EpsonNet Config, select NetWare from the Network tab,
and then specify the following settings.
❏ NetWare Print: Select Enable.
❏ Frame Type:
Select Auto. (Select the frame type according to the network environment.)
❏ Mode: Select PServer.
❏ Print Server Name: Specify the print server name created in step 4.
❏ Print Server Password: Specify only when setting from the Net-Ware server.
❏ Print Queue Scan Rate: Specify 1. (Change as necessary.)
❏ Bindery/NDS: Select NDS.
❏ Preferred NDS Context Name:
Specify the name of the context that connects to Pserver.
❏ Preferred NDS Tree Name:
Specify the name of the tree that Pserver logs on to.
6. Restart the printer.
7. Use the NetWare server console to load MONITOR.NLM.
8. Select the connection information and, in the active connection column, check that the created
Pserver is connected.
For NetWare 5.x/6 Novell Distributed Print Service (NDPS)
Note:
❏ Before specifying settings for NDPS, check that the NDPS broker and NDPS manager have been
created and loaded.
❏ Also, before performing the following procedure, check that the TCP/ IP protocol has been set in the
NetWare server, and check that the IP address has been set for this machine and that this machine is
on.
1. Log on to NetWare as an administrator from a client computer.
2. Start up NWadmin.
Epson AcuLaser CX37 Series Reference Guide
Operation on NetWare 40