RISCO Group ProSYS 128 - Manual (Page 11)

Access Control User's Manual 11
Chapter 2: Using the Access Control
Module
The Access Control module can be used to allow
entering/exiting doors and for arming/disarming the security
system.
Entering/Exiting Doors
Doors that are defined to operate in automatic mode can be
entered/exited by all users with access cards or access codes.
The access card or code must:
x Used only during its assigned time windows.
x Used only with its assigned doors.
In addition, doors can be programmed to have a fixed status
(Always Open or Always Closed) or can be programmed to
open when a motion detector detects movement. In this case,
users can enter/exit normally without using their access card or
code.
¾
To enter/exit the system:
x Present your card or code to the reader, using the required
method (depending on the reader type). The system verifies
the card or code (indicated by a confirmation LED and
beep) and opens the door.
NOTES:
If a wrong code or an unknown card is entered five times, a false code
announcement is sent to the monitoring station.
Users with Entrance Only cards cannot enter a door if all the door
partitions are armed (refer to Adding Enter/Exit Users, page 29).
Arming/Disarming the System
The system can be armed/disarmed only by users who have
been assigned with arm/disarm rights. To arm/disarm the system,
the following criteria must be met: