RISCO Group ProSYS 128 - Manual (Page 19)

Access Control User's Manual 19
Defining the Reader Type 6 6 8 8 CODE CODE # # 1 1 2 2
The reader type option enables you to define the access type
and level of security for each reader. This consists of defining
which type of reader is installed on each door and defining
whether or not the system can be armed and/or disarmed from
the reader. For example, you may have two readers at the
entrance of your premises, but you only want the system to be
armed from the inside reader and disarmed from the outside
reader.
NOTES:
The reader type depends on the installed reader.
The system enables you to have different reader technologies throughout your
premises, but each Access Control module can support only one technology.
When performing this procedure, use the data that you
prepared in Table 2: Readers, page 39.
¾
To define the reader type:
1)
ACCESS CONTROL:
1) SETTINGS
ACCESS CONTROL:
1) SETTINGS
From the Access Control menu,
select
[1] Settings.
2)
SETTINGS:
1) DOOR MODE
SETTINGS:
1) DOOR MODE
Select [2] Reader Type.
3)
SELECT A READER:
01) READER 01
SELECT A READER:
01) READER 01
Select the appropriate reader
number and then press
.
4)
READER TYPE
1) CARD ONLY
READER TYPE
1) CARD ONLY
Define the reader type (depending
on the installed reader type) by
selecting the appropriate option:
[1] Card Only: Enables door access by using an
access card in the reader. After selecting this option,
select [Y] Yes or
[N] No to define the disarm rights. (This option only
allows users to disarm the system.)