RISCO Group ProSYS 128 - Manual (Page 13)

Access Control User's Manual 13
¾
To disarm the system:
x If the reader is defined as a Keypad Only or Card Only or
Keypad/Card type, enter your PIN code using the keypad
OR pass your access card in the reader, as required:
PIN CODE + [#] or PASS CARD
-OR-
x If the reader is defined as a Keypad + Card type, pass your
access card in the reader AND then enter your PIN code
using the keypad:
PASS CARD + PIN CODE + [#]
Duress Disarming
You can also use the Access Control readers (Keypad Only,
Keypad/Card, and Keypad + Card types) for duress disarming.
This type of disarming sends a quiet alarm to the monitoring
station while you disarm the system under coerciveness.
The duress code is automatically the number following the user's
PIN code (for example: PIN code = 1234; duress code = 1235).
Refer to the ProSYS User's Manual for additional details.
¾
To perform duress disarming:
x If the reader is defined as a Keypad Only or a Keypad/Card
type, enter the next sequential number after your PIN code:
[PIN CODE + 1] + [#]
-OR-
x If the reader is defined as a Keypad + Card type, pass your
access card in the reader and then enter the next sequential
number after your PIN code:
PASS CARD + [PIN CODE + 1] + [#]