TA Triumph-Adler 261ci - Manual (Page 145)

7-10
Using a Connected Telephone > Remote Switch Function
Remote Switch Function
You can start fax reception by operation from the connected telephone set. This function is convenient for using this
machine and a telephone set (commercially available product) in combination installed at places distant from each other.
Using the Remote Switch Dial
To start fax reception by operation from the connected telephone set, use the following
operation.
1
The connected telephone set makes a ringing tone.
Lift the handset of the telephone.
2
Press the remote switch dial number (2 digits).
When you hear the fax tone from the handset, enter the two-digit remote switch dial number
using the dial button on the telephone set. The telephone line switches to the machine, and
reception starts.
NOTE
In order to use remote switch, it is necessary to connect the tone signal-sending telephone
set (commercially available product) to the machine. However, even if it is a tone signal-
sending telephone set, this function may not be used satisfactorily depending on the type of
telephone set. For details, contact our agent or the store where you purchased this
machine.
The remote switch dial is set to 55 at the factory.
The remote switch dial number can be changed. Refer to Reception on page 9-8 .
NOTE
You can change the number of times the ringing tone rings. (Refer to Reception on page 9-8 .)