PLANET WNAP-6306 - Manual (Page 22)

User’s Manual of WNAP-6306
- 22 -
3.2 Hardware Installation
3.2.1 Connect Up
Step 1. Connect the Antenna to the top of WNAP-6306.
Figure 3-1 Connect Antenna
Step 2. (1) Open the bottom of WNAP-6306.
(2) Plug the RJ-45 Ethernet cable into the LAN Port through the Cap and Gasket. Then seal
the bottom of the WNAP-6306 with the Cap and Gasket.
Figure 3-2 Cable Connection
1. Ensure to pack the Gasket into the Cap tightly to avoid the penetration of
water.
2. Do not remove or lose the Rubber ring that fits over the spiral groove on
the bottom of the WNAP-6306, otherwise, the product may be damaged by
the penetration of water.
3. RJ-45 8P8C Ethernet cable is required.