PLANET WNAP-6306 - Manual (Page 48)

User’s Manual of WNAP-6306
Transmission Rate
Transmit rate indicates the transmission speed of wireless LAN
access .The default setting is “Auto” and you can set this value
between 1-150Mbps range.
ShortGi
You can select “Enable” or “Disable” for shortgi. It is used to set
the time that the receiver waits for RF reflections to settle out
before sampling data.
Protection
Using 802.11b and 802.11g mixed mode may result in poor
network performance. By enabling 802.11 protection, it will
ameliorate performance of 802.11g devices in your wireless
network.
Preamble Type
"Short Preamble" is suitable for heavy traffic wireless network.
"Long Preamble" provides much communication reliability; the
default setting is "Long Preamble”.
WLAN Partition
This feature is to isolate the communication of wireless clients
connected with different AP. When this feature is enabled, each of
your wireless clients will be in its own virtual network and will not
be able to communicate with each other.
RF Output Power
Set the wireless output power level. The default value is 100%.
WMM
To enhance wireless multimedia transfer performance (0n-line
video and voice).
5.4.2 Multiple AP Setup
The wireless AP supports multiple AP, if you need to open more than one AP, you can choose to open
vice AP function. The default status of secondary AP is disabled; you can select enable to enable the
secondary AP. Please refer to “Wireless Setup Basic” and “Wireless Security” for details.
5.4.2.1 Basic
The default status of secondary AP is disable, you can select enable to enable the secondary
AP. Please refer to 5.3.1.1 Wireless Basic for details
- 48 -