PLANET WNAP-6306 - Manual (Page 38)

User’s Manual of WNAP-6306
wireless AP will be turned off.
Radio band
You can select the wireless standards running on your network, if you
have Wireless-N, and Wireless-B/G devices in your network, keep the
default setting to “802.11b+g+n”.
Radio mode
You can select radio mode of wireless AP, it contains Access Point,
Client, AP+WDS, Repeater and Lazy. The default setting is AP mode.
SSID The default SSID is “Default”.
SSID Broadcasting
You can select “enable” or “disable” to enable or disable the broadcast
SSID function, If the setting of this field is disable, wireless client can’t
obtain this SSID to login in, then user have to input the SSID value
manually.
Channel width This switch allows you to set AP's wireless bandwidth.
20MHz: In this mode you can get low bandwidth, little interference and
slow rate.
40MHz: In this mode you can get high bandwidth, high interference
and rapid rate.
Channel sideband It controls your wireless AP use higher or lower channel when working
on 40MHz.
Region please select the region where you live in.
Channel
In 20MHz, you can select one channel from 1 to 13 manually, and in
40MHz, you can select one channel from 1 to 9 or 5 to 13, which
provides a choice of avoiding interference.
5.4.1.2 Security
The item allows you to encrypt your wireless communication, and you can also protect your wireless
network from unauthorized user access. It supplies “None”, “WEP”, “WPA-PSK”, “WPA2-PSK” and
“WPA/WPA2-PSK” five different encryption modes.
A. None
“None” means do not encrypt wireless data.
- 38 -