PLANET WNAP-6306 - Manual (Page 23)

User’s Manual of WNAP-6306
Step 3. (1) Plug the other side of the RJ-45 cable in the STEP 2 into the PoE port of the PoE Injector.
(2) Plug another RJ-45 cable into the LAN port of PoE Injector, and the other side plug into
the LAN port of PC or Switch.
(3) Plug the 18V PoE Injector into the Power Outlet. For UK and other regions, you need to
supply the power by the 15V AC Adapter.
Figure 3-3 PoE Installation
1. It will take about 30 seconds to complete the boot up sequence after powered on
the Outdoor AP; Power LED will be active, and after that the WLAN Activity LED
will be flashing to show the WLAN interface is enabled and working now.
2. Be reminded, the UTP wire distance toward your WNAP-6306 to the Ethernet
devices, such as Ethernet Switch, is 100 meters, the passive POE injector can be
in any point of this 100 meters UTP distance where there is a shell or protected
location.
3. To avoid thunder strike, consider to install ELA-100, thunder arrester toward the
CPE AP and the PoE injector.
- 23 -