ProSoft Technology MVI56E-SIE - Manual (Page 36)

Start Here MVI56E-SIE ♦ ControlLogix Platform
User Manual Client Communication Module
Page 36 of 168 ProSoft Technology, Inc.
September 6, 2012
1.9 Downloading the Sample Program to the Processor
Note: The key switch on the front of the ControlLogix processor must be in the
REM
or PROG position.
1 If the processor is not already online, open the Communications menu, and
then choose D OWNLOAD . RSLogix 5000 will establish communication with the
processor. Download does not have to occur using the processor's serial
port, as shown here. Download may be achieved through any available
network connection.
2 When communication is established, RSLogix 5000 will open a confirmation
dialog box. Click the D OWNLOAD button to transfer the sample program to the
processor.
3 RSLogix 5000 will compile the program and transfer it to the processor. This
process may take a few minutes.
4 When the download is complete, RSLogix 5000 will open another
confirmation dialog box. If the key switch is in the REM position, click OK to
switch the processor from PROGRAM mode to RUN mode.
Note: If an error message is recieved during these steps, refer to the RSLogix
documentation to interpret and correct the error.