Epson 9300i - Manual (Page 105)

Maintaining the Projector 105
Resetting the Lamp Timer
After you replace the lamp, you need to reset the lamp timer using the
projector’s menu.
1. Press the Menu button on the remote control (or on the
projector’s control panel). You see the main menu.
2. Use the pointer button on the remote control (or the arrow
buttons on the projector) to highlight About , then press Enter .
You see this screen:
3. Select Reset Lamp Timer , then press Enter . You see this
prompt:
4. Select Yes , then press Enter .
5. When you’re finished, press E SC or Menu to exit.
note
The lamp usage timer shows
0H until you’ve used the
lamp for at least 10 hours.
Video
Audio
Setting
User’s Logo
Advanced1
About
Reset All
Frequency Frequency
Source Source
V ---.---Hz V ---.---Hz
Reset Lamp Timer Reset Lamp Timer
H ---.---kHz H ---.---kHz
Lamp Lamp 0H 0H
SYNC Mode SYNC Mode
SYNC Polarity SYNC Polarity
------
V ------ V ------
H ------ H ------
Resolution Resolution
Refresh Rate Refresh Rate ---.-- Hz ---.-- Hz
----x ---- ----x ----
Computer1 Computer1
Input Signal Input Signal
:
:
:
:
:
:
:
:
: Analog-RGB Analog-RGB
Execute Execute
[ ]: Select [ ]: Select [ ]: Enter [ ]: Enter [Menu]: Exit [Menu]: Exit
Effect
Advanced2
:
Lamp usage
Reset Lamp Timer Reset Lamp Timer
Execute?
YES NO
Reset Lamp Timer Reset Lamp Timer
Execute?
YES NO