Epson 9300i - Manual (Page 23)

Setting Up the Projector 23
Connecting a Component Video Source
1. Locate a component video cable (one may be included with your
video equipment).
Look at the connectors at one end of the cable. If they are
bayonet-style (BNC) connectors, continue on to the next step. If
they are RCA connectors, you’ll need to attach commercially
available BNC adapters to plug the cable into your projector.
2. Connect the cable (with the adapters) to your player and the BNC
connectors on the projector. Match the Y/Cb/Cr (or Y/Pb/Pr)
connectors on your player to the corresponding connectors on the
projector.
3. If you want to play sound through the projector, see page 33 for
instructions on connecting an audio cable.
4. If you don’t need to make any other connections, see Chapter 2
for instructions on turning on the projector and adjusting the
image. Once the projector is turned on, be sure to do the
following:
■ Enter the projector’s Setting menu, then change the BNC
Input setting to
YCbCr or YPbPr , as needed (see page 75).
■ After exiting the menu system, select BNC as the source to see
your image (see page 38).
BNC adapters