Epson 9300i - Manual (Page 37)

Displaying and Adjusting the Image 37
3. Press the red Power button on top of the projector—or press the
Power button on the remote control.
(If this is your first time using the remote control, make sure the
batteries are installed and the power switch on the side of the
remote is turned on; see page 50.)
The Ppower light flashes green as the projector warms up, and an
image begins to appear. When the power light stops flashing and
remains green (in about 40 seconds) the projector is ready for use.
If you’ve enabled password protect, enter your password at the
prompt. (See page 78 for details.)
4. If you’ve connected a Windows-based computer to the projector,
you may see a New Hardware Wizard saying your computer has
found a plug-and-play monitor; if so, click
Cancel .
If you want to allow the projector to turn on directly when you plug it
in (or when you turn on the power when the projector is plugged in to
a wall switch-controlled outlet) you can enable the direct power on
option. See page 74 for details.
Turn on
remote
Power button
warning
Never look into the lens
when the lamp is on. This
can damage your eyes, and is
especially dangerous for
children.