Epson 9300i - Manual (Page 84)

84 Managing the Projector from a Remote Computer
Connecting and Configuring the
Projector
Before using the EMP software to manage your projector(s), you have
to connect each projector you want to monitor to your network and
configure it with an appropriate IP address.
1. Connect the projector to your network using a commercially
available 100baseTX or 10baseT category 5 shielded twisted-pair
network cable.
Connect the cable to the ethernet port on the projector as shown.
2. Turn on the projector (see page 36).
3. Press the Menu button on the remote control and select Network
from the Advanced2 menu.
4. If your network assigns addresses automatically, turn on DHCP .
caution
You must use a category 5
shielded twisted-pair cable
to connect to the LAN to
prevent malfunction.
To network port
Ethernet port
note
Make sure the Standby
Mode setting in the
Advanced1 menu is on, or
you won’t be able to view or
change the projector’s
network settings.
: Video
Audio
Setting
User’s Logo
Advanced1
About
Reset All
Reset Execute
[Menu]: Exit [Menu]: Exit [ ]: Enter [ ]: Select
Effect
Advanced2
BNC Sync Termination ermination ON OFF :
Projector ID
Network
: 1
COM Port :
Set
Set
RS-232C USB
Auto Setup ON OFF :
Direct Power ON ON OFF :
Select Network