Epson 9300i - Manual (Page 52)

52 Giving Your Presentation
Controlling Multiple Projectors
If you’re using more than one projector, you can control all the
projectors—or just selected ones—by using the projector ID system.
To operate a projector, you have to set the remote control’s ID to
match that of the projector. Or you can control all of the projectors
simultaneously by setting the remote control’s ID to zero.
Setting the Projector ID
The projector’s default ID is 1. If you need to change it, follow these
steps:
1. Press the Menu button on the remote control.
You see the projector’s menu screen.
2. Enter the Advanced2 menu and highlight Projector ID .
3. Press the right or left side of the pointer button to increase or
decrease the ID value.
4. Press Enter to set the value.
5. When done, press E SC to exit the menu system.
Brightness Control Brightness Control High High Low : Video
Audio
Setting
User’s Logo
Advanced1
About
Reset All
Projector ID Projector ID
Network Network
Reset Reset Execute Execute
: 1
[Menu]: Exit [Menu]: Exit
Effect
Advanced2
COM Port COM Port
BNC Sync BNC Sync Termination ermination
:
ON ON OFF OFF :
Set Set
Set Set
RS-232C RS-232C USB USB
[ / ]: Select [ / ]: Select [ ESC ]: Return [ ESC ]: Return [ ]: Set [ ]: Set
Auto Setup Auto Setup : OFF OFF : ON ON