Epson 9300i - Manual (Page 79)

Fine-tuning the Projector 79
Enter up to four numeric characters for the time: press the Num
button on the remote control and then use the numeric keypad
buttons to enter a setting time within the range of 0 to 9999
hours, then press
Enter . (If you make a mistake entering the time,
press the Esc button and re-enter the time.)
The time countdown starts after you finish using the Password
Protect menu.
4. To enable User’s Logo Protect to prevent your custom A/V Mute
and power on screens from being changed:
Use the pointer button to highlight User’s Logo Protect ,
then choose ON and press the Enter button to select it.
5. To set your password, use the pointer button to highlight
Password , then press the Enter button.
6. When you see the message “Change the password?” select Yes
and then press Enter .
7. The default setting for the password is “0000.” Change this to
your own desired password: press the Num button on the remote
control, then use the numeric keypad to enter a 4-digit number.
The password appears as
* * * * on the screen.
After you enter the last digit, you see a confirmation screen.
8. Re-enter the password that you entered in step 7.
If you enter the correct password, the message “The new password
is stored.” appears.
If you enter the password incorrectly, a message prompting you to
re-enter the password appears. Select
Yes and press the Enter
button to re-enter your password.
9. When you finish entering your password, press the Enter button.
10. Press the Num button on the remote control to cancel numeric
keypad mode, if necessary. (Make sure the Num button light is
turned off.)
11. Press the Menu button to exit the password protection screen.
note
If the length of time is set to
“0,” the password entry
screen only appears when the
power is turned on the first
time after the projector has
been plugged in.
note
Make a note of your
password and keep it in a
safe place. Do not lose the
remote control. You must
use the remote to enter your
password.